93 Mauser stripper clip
93 Mauser stripper clip, 7MM.
These work fine on Springfield
and 1917 Enfield 30/06 cal.
rifles. May have minor surface
rust (not pitted). Steel shell type
Stripper clip, brass
93 Mauser 7mm stripper clip, with
brass shell. These work fine on
Springfield and 1917 Enfield 30/06
Cal. rifles. They hold five rounds per clip.
Sear spring for either the 03 or
03/A3 Springfield. NEW, un issed original.
WW2 type pull thru. Steel, NEW.
Used on Springfield, M1 Garand, Etc.
With out brush. Photos show brush which
are not included.
Pull thru, brass U.S.G.I.
Later post WW2 type, NEW
with brush. There are two
types; one with the cord tied
to the brass and the other with
the cord held on by brass fasteners.
These are the tied on type.
03 windage knob
03 rear sight windage knob (only).
Replacement knob riveted on
Pull thru post WW2 type, Brass
with brush. Two types; one with
the cord tied to the brass and the
other with the cord held on by
brass fasteners. These are the
cord held on by brass fasteners type.
Bolt sleeve lock
Bolt sleeve lock with spring and pin.
Like new condition. For both 03 and
03 striker with out markings.
Blued, used very good condition.
Cut off S.C.
Cut Off made by Smith & Corona
Typewriter Co. New, Un issued.
They were not marked. These come
from original Smith & Corona packaging.
Cut Off, 03
03 Cut Off made by General
Machine & Mfg. Co. New, un
A3 S.C. stacking swivel
03/A3 stacking swivel made by
Smith & Corona Typewriter Co. New,
un issued. They are parkerized
with out markings. Un marked blued
stacking swivels are Remington mfg.
Ejector made by or for Springfield
Armory. Like new condition.
03 sear w/o mark
03 Sear with out markings.
These do not have the sear spring hole
and are most likely pre or early WW2
Springfield Armory manufacture as some
(not listed) have the WW2 sear spring hole.
They could also be made for Springfield
Armory by a subcontractor or re finished earlier
03 sears. We have thousands of sears in stock
that need sorted so will add to sear listing more in